How to make a hummingbird bird

Despite the apparent complexity, this bird is easy to make. Look how good it looks among the greenery! To do this, take thick paper - it will hold its shape better. And there are few folds in this craft.
A hummingbird is made from a triangle. To do this, fold the square sheet in half diagonally and cut it.

You won't need the second triangle.
Place the workpiece at a right angle downward. Fold in half and unfold again.

Fold the sides towards the middle.

Fold it towards the center line again, but this time from the bottom.

Expand.

Open the top sheets. You will see folds inside. Bend the sides along them inwards.

And lower the upper movable part of the workpiece down. Do the same on the right side.

You have such a figure.

Bend it back along the center line.

Upper part crafts bend it down at a right angle. There will be a thickening on the fold, but that's how it should be. Just press that spot well.

Unbend the part.

Fold the bottom part of the top sheet in half - from the fold to the center line.

Grab the bottom fold and pull it up. The central vertical line should be in a horizontal position.

And you should end up with a diamond like this.

Do the same on the other side of the figure.
Unscrew the top of the diamond and draw a line at a right angle from the middle of the diamond to the outside of the top triangle.

At the bottom of the figure, draw a horizontal line to the middle of the craft.
Bend the pieces along these lines.

Above these lines, draw “darts”.

Bend them too.

Fold the top “dart” inward.

Bend the lower sharp part of the figure with a step.

Now rotate the figure clockwise 90 degrees.

Large diamond wings were at the top.
Shape the bird's head. Draw a line below the fold.

Bend it with a step.

Unfold the edge of the sharp corner. Bend its sides from the sides inward. You will end up with a sharp beak. Grasp the beak and head and bend the part inward along the bottom fold.