5 creative ideas for the DIYer

We present another selection of interesting ideas for the DIYer. It includes creative solutions for advanced craftsmen and those who like to occasionally fix something with their own hands. All the tips work great and deserve your attention.

1. Precise gluing with superglue

To accurately apply superglue exactly to the gluing area, you can put a syringe needle on its spout.

This will reduce its consumption and eliminate leaks. You can also use needles to pour glue into hard-to-reach places.

2. Cover for the drill

The drill does not have a protective casing like an angle grinder, so when working, sparks and sawdust can fly off from it. You can make a casing from the neck cut off from a transparent plastic bottle. This requires minimal modification. First you need to drill the cover with a 16 mm drill.

High-quality and durable drills on AliExpress at a discount - http://alii.pub/5zwmxz

Next, part of the wall is removed from the workpiece.

Now you can put it on the drill.

After this, sparks and sawdust will not fly in your face. If over time the casing darkens and is no longer transparent enough, you can make a new one in 2 minutes.

3.Storing opened sealants in a tube

After opening the sealants in the tube, they begin to dry out in the spout, since it does not close tightly enough. To block air access, you can stick tape on the spout, bending it in half.

In addition, you can punch a hole in it and hang the sealant on a nail.

4. Pipe cable lug

To connect powerful wires, cable lugs are used. They do not have to be purchased; it is enough to have a piece of tube of a suitable cross-section for the wire core. The tube is flattened at one end.

Then its corners are ground off and it becomes translucent.

The resulting tip is placed on the core stripped of insulation. You can compress it with pliers, a vice, or hammer blows.

5. Wire twister

To twist loops from rigid wire, you can make a special tool. A longitudinal cut of 2-3 cm is made in the pin or rod on one side. A hole is drilled in the same direction at a distance of 5-10 mm from it.

You need to screw a self-tapping screw into the hole.

Now fold the wire in half. Its long rod is inserted into the cut of the tool, and the short end is engaged with a self-tapping screw. We rotate the tool, thereby twisting the loop turn to turn.