Device for obtaining “dead” and “living” water
Remember how in the old Russian fairy tale: in order to revive the hero you need to sprinkle him with “dead” water, and then give him “alive” water. Today, “living” and “dead” water is not fiction or science fiction. Of course, it is literally impossible to revive or kill someone with the action of such water, but such water does have healing properties.
"Living" water Alkaline water is considered (pH = 10-11 units). Water softens the skin, has healing properties, has a rejuvenating effect, removes allergies, and makes hair silky and healthy.
"Dead" water acidic (pH = 4-5 units), has good bactericidal and disinfectant properties, is used to rinse the mouth, throat and nose for colds, lowers blood pressure, destroys eczema, fungus, lichen, helps with diarrhea.
You can make a device for obtaining “living” and “dead” water with your own hands. To complete this task you will need:
•2 stainless steel electrodes;
•tarpaulin bag;
•glass container (jar);
•diode rectifier bridge for converting alternating voltage to direct voltage;
•power cord with plug;
•plastic cover.
1. To make a tarpaulin bag you will need a non-rubberized tarpaulin, you can use a fire hose (50 mm in diameter). The length of the bag should correspond to the height of the glass jar into which it will be inserted. A bag is made from a tarpaulin cut to the required length. To do this, one side (the bottom of the bag) is sewn up with a piece of the same tarpaulin or a piece of food-grade plastic is inserted, as in our case.
2. Then two electrodes (25x125x2) are made from stainless steel grade 44 NTHYU.
3. Insert the electrodes into the plastic lid (you can use a regular plastic lid for jars). In this case, the lid from a plastic coffee maker was used. The distance between the plates is 40 mm.
4. To the electrode plates, according to the diagram shown in Figure 1.
Fig.1 Schematic and structural diagram of a “living” and “dead” water device.
Connect the diode rectifier bridge, marking the plus (+) and minus (-) outputs on the plate; for safety reasons, you need to cover the bridge with a lid.
5. A power cord (500-700 mm long) with a plug is connected to the diode bridge. All exposed electrical connections are carefully insulated. The device operates on alternating voltage 220 V.
6.Insert the bag into a glass jar and pour water into both containers.
7. Place the electrode with a minus sign (-) in a tarpaulin bag, the second electrode (+) is placed in a jar and connected to the network
8. The process of preparing water takes from 3 to 8 minutes. In the photo you can see the process itself.
Similar master classes
Particularly interesting
Comments (14)