How to make a huge LED

Have you ever held a huge Light-emitting diode, the size of a human fist? Of course not, because they don't exist. I'll show you how to make such an original thing with your own hands. This is LED Light-emitting diode will be exactly like its small brother, except that the brightness of its glow will be many times greater.

Will need

• Plastic bottle.
  
• The board is textolite, foil-coated.
  
• Thick wire.
  
• A piece of LED strip.
  
• Resistor 5-10 Ohm.
  
• Epoxy resin with hardener.

Making a large LED

So, let’s first figure out what it consists of Light-emitting diode. The first is two outputs that go into the body LED. Next you can see two pads, one smaller is the anode, and the other larger is the cathode. On the cathode there is a platform with a reflector and a semiconductor crystal. Above all this there is a lens, which is a monolith with a body LED.

First, let's make an imitation of a large semiconductor crystal with a reflector. We take the LED strip and solder the chip elements from it. If you don’t have a hairdryer, heat it up with a soldering iron.

Let's cut out such a board from a piece of foil PCB.

We tin it and solder the LED chip onto it.

We also solder the contact and the current-extinguishing resistor.

Let's check the power supply. The crystal is ready.

For greater visual similarity, we will cut out the cathode and anode from PCB.

The elements are located at the bottom of the body.

We take a thick wire and make contacts from it. We solder them to the pads.

Next, we coat the light module with hot glue and glue it perpendicularly to the largest area - the cathode.


Solder the pins to the board.

Next we need to prepare a mold for pouring epoxy resin. A plastic bottle will serve us for this purpose.

Let's cut it in the middle and put the top part on the bottom.

There is an empty area in the lid area where the epoxy will be poured. In order not to waste extra material, we fill the voids of the neck with foil.

Strictly according to the instructions, mix the hardener with the resin and mix well.

We fix the insides with office clips so that they float in the air. Pour the composition into the mold.

We are waiting 24 hours. After drying, cut the bottle with a scalpel and remove parts of the bottle from the surface.

This is what happened:

Using a mechanical tool, we cut off the foil and polish the surface irregularities.



Sand with fine sandpaper, dipping it in water. This will remove all the smallest scratches.


It's time to polish. Polishing paste can be obtained from motorists. In extreme cases, toothpaste will do.

Apply the paste and polish with a soft cloth until transparent.


Very similar to the original.

Checking

We serve food.

It shines great!



Shines in complete darkness.

Now you can surprise your friends.

Watch the video