How to drill a wall without dropping a crumb on the floor without a vacuum cleaner

If for some reason you cannot use a vacuum cleaner when drilling a wall, then this life hack will be very helpful. Helpful advice will teach you how to drill a hole in the wall cleanly, without dust and construction dirt. No expensive equipment or materials are needed.

Will need

• Drill or crown.
• Paper.
• Plastic bottle.
• Stationery knife.
• Stapler.
• Masking tape.
• Drill and wall for drilling respectively.

How to drill a wall without dust and crumbs

Using a utility knife, cut off the bottom of a plastic bottle.

If the edge is uneven and does not fit tightly to a flat surface, it can be ground by hand on any concrete surface.

Next, drill a hole in the center of the bottom of the bottle. The diameter of which should be 1.5-2 times larger than the working drill.

Take a sheet of paper, fold it into an envelope and secure it with a stapler.

Using masking tape, glue the envelope under the drill mark.

Now let's move on to drilling.We install the bottom of the bottle and drill the wall through it.

The bottom of the bottle will prevent concrete crumbs from scattering when drilling. At the end of the work, all that remains is to remove the drill and empty the contents into the envelope below.

The envelope can then be used to drill other holes. When finished, roll up and throw in the trash.

Agree, the result is no worse than with a vacuum cleaner: the wall is clean, there are no construction products on the floor, everything is free of dust and dirt.

Watch the video