Sew a sleep mask

In order to sew a sleep mask, you will need the following materials and tools:
1. A small piece of white satin with jacquard weave;
2. Thin adhesive pad (proclamylin or knitted);
3. White calico;
4. White bias tape;
5. Spool of white thread;
6. Narrow elastic with an openwork edge;
7. Dried lavender flowers, about 5 g;
8. Cardboard;
9. Simple pencil;
10. Ruler;
11. Scissors;
12. Needle for hand sewing;
13. Sewing machine;
14. Cotton iron;
15. Pins;
16. Iron.

First of all, you need to make a mask pattern from cardboard. It should be 20 cm long and 10 cm wide.
There is no need to give seam allowances to the pattern, since the mask will be edged with tape.
An incision will be made approximately 3.5 cm from one edge on the underside of the mask. It is needed so that, if necessary, the sachet with dried flowers can be taken out and the mask can be washed.
According to the pattern, you should cut out the front part of the mask (solid), the back part of the mask (split, with an allowance of 1.5 cm for processing the cut), as well as 2 parts from the adhesive gasket.

The front and back parts of the mask must be glued using an ironing iron. Allowances for processing the cut on the wrong side should be ironed by 1.5 cm.

Allowances for processing the cut must be tucked and stitched.

The front and back parts of the mask should be sewn together along the edge. At the same time, they should “look” at each other with wrong sides.

Then you need to pin the elastic band to the mask. Its length is determined individually experimentally.

After this, you need to sew bias tape on the wrong side of the mask.

Next, the bias tape should be turned onto the front side of the mask and stitched at a distance of 1 mm from the ironed fold.
If necessary, the mask can be carefully ironed from the wrong side through an ironing iron.

From white calico you need to cut out a sachet for dried flowers - a rectangle with dimensions of 13*17 cm. One cross section of the part must be ironed 1 cm towards the wrong side.

Then the sachet needs to be folded in half lengthwise and stitched along one long and one short side.

After this, the sachet needs to be turned out onto the face and ironed.

Using a spoon, fill the sachet with dried lavender flowers.

The filled bag should be stitched on a typewriter. Dried flowers should be spread evenly throughout the sachet with your fingers.

Now the lavender sachet can be inserted into the mask.

The fragrant sleep mask is ready!