Bike rack

This is such a wonderful one bike rack anyone can do it. It's just a bike holder. Agree - leaning a bicycle on the wall is not as good as it seems - it often falls and the kickstand does not always save you. . .

You will need PVC pipes and PVC glue, as well as all sorts of elbow grease. It all depends on your imagination and the size of your iron horse.

Good luck !

come back

Similar master classes

Bicycle wheel lighting

How to make a manual potato hiller from an old bicycle

A stand for an angle grinder made from the handle of a children's bicycle. Extremely

A simple stand for an angle grinder made from a bicycle

Bicycle generator

Ice access

Particularly interesting

3G 4G antenna with a range of more than 30 km

Cable antenna for digital TV in 5 minutes

How to restore a bat

An innovative way to connect two wires

Eternal log to save on firewood

Night vision device from an old camera

Comments (5)

#1 ssd Guests 2 April 2013 23:11
3

How were the pipes inserted into the elbows? You can’t plug them in without soldering.. Can you be more specific?
- Answer
#2 cipa Guests 25 April 2013 14:26
2

Can you tell me what size this stand is? We will have approximately the same bicycles, plus or minus a couple of cm. I wonder how you did it. Thank you in advance )
- Answer
#3 Novel Guests 7 February 2015 20:15
1

Why glue? So you need to solder polypropylene!
- Answer
#4 kirill Guests 18 July 2015 13:53
1

These are pipes that are glued and not soldered.
that's what glue is for)
- Answer
#5 Evgen Guests 23 December 2018 17:53
0

This is the bomb dude. I wanted to make something out of metal, but why if there is such a thing!
- Answer