paper dragon

Dragons are found in the mythology of many peoples and are sometimes revered as sacred animals - just remember the Chinese Dragon Festival, in honor of which an annual kite festival is held. Fictional or real, dragons in the minds of many are strong, powerful, huge, certainly fire-breathing and extremely beautiful creatures. Getting your hands on such a scaly life-size beauty is very problematic, but quickly and easily making a miniature copy of it from paper is as easy as shelling pears. This master class will introduce you to one of the many ways to make a dragon using the technique origami.

All you need is a square piece of paper of any size and a few free minutes.
To begin, bend the sheet diagonally.

The resulting triangle is also bent in half and in half again.

Next, unfold the sheet to its original state and again bend it diagonally.

Using the resulting folds, fold the sheet into a double square and place it in the shape of a diamond, with the folds facing up.

Then fold the corners of the diamond towards the center on both sides.

First bend the remaining top completely, not forgetting to iron it thoroughly, and then, having straightened it, lower the very corner of the upper part to the fold line, again ironing it.

Unfold the sheet completely.

Notice that a small square has appeared in the center of the sheet. We carefully begin to fold the workpiece around this square, and then bend it inward.

Then bend the protruding triangular parts inward so that you get a figure somewhat similar to a diamond.

Bend the protruding “ears” of the figure towards the center, and then, following the photo, unfold the parts of the workpiece to a rhombus and fold the entire workpiece in half so that you get two acute-angled triangles separated from each other - the future head and tail, and two wings.

Afterwards we form the blank for the wings. To do this, bend the lower edge of the diamond in different directions, then bend it along the resulting lines.

We do the same on the other side.

We fold the remaining two points so that they are parallel to the bent wings.

We bend each part of the future head and tail in half, then unfold and fold it as in the photo - these are the paws of our dragon.

You can bend them right away.

In order not to leave the animal headless, bend one of the head-tails perpendicular to the body and bend it in the opposite direction to the original one, and then form its head with two small bends.

In this case, it does not matter at all on which side your dragon’s head will be located and which side its tail will be located.
The tail can be absolutely anything: it can be bent in a zigzag, unfolded, twisted, wrinkled - just let your imagination run wild!