Rocking chair for mobile phone

Hello!

Here's a homemade product. Rocking chair for mobile phone.

A second use option is possible - as a business card holder.

Material - furniture board, or plywood, or just a piece of board. PVA. A pair of clamps.

1 The sides of the chair are quarters of a circle, radius 96 mm. We cut it out with a jigsaw or a hacksaw and trim it with a sandpaper.

2 The back of the chair is a rectangle 100 by 55.

3 The seat of the chair is again a rectangle 50 by 55. (55 mm is the width for a small Nokia. If you make it for a smartphone, you need 65)

4 Cut it out of the board, sand it and mill it.

5 Glue the back and seat together.

6 Optional - after gluing, it would be good to smooth out the joint from below between the seat and back with sandpaper - so that there is no unpleasant step-roughness.

7 Then we glue the sides of the chair.

8 Optional - varnish

9 And also optional - drill a hole for the charging connector so that the phone can be charged while lying in a chair. In the photographed copy there is such a hole, it is in the seat under the phone.