Mini-wash from leftover PVC pipes and bottles

From a few pieces of PVC pipe and a plastic bottle, you can make a simple sink for your bicycle, motorcycle or even car.
This type of sink operates from a central water supply and the principle of its operation is as follows: If you simply open a pipe with water, then the pressure in it will immediately drop and, therefore, its pressure will not be so strong. This washer, thanks to the bottle, will accumulate pressure, as a result the output pressure will be stable for a short time.

Making a simple mini-wash

Berm two PVC triangles.

Using a piece of pipe, we connect them and place them on glue.

We blank out one side of the triangle - it will not be needed later. This elongated plug will serve as a support for the entire structure.

You need to insert a bottle (2 liters) into the middle of one triangle. To do this, use a lighter to heat the seat and insert the neck.

As soon as everything has cooled down, take out the neck, coat it with glue and insert it again. Re-fix the top with glue.

We glue pipe sections into the elbows from the triangles to connect the hoses.

We take the faucet and glue the body of the plastic handle into it - this will be the nozzle for the water outlet.

On the other side we make an exit for the hose.

The installation is connected to the central water supply. We connect the hose from the outlet to the sink.

We connect the outlet from the sink to a gun with a nozzle.

We serve water. We wait until the pressure inside the bottle increases and it is half filled - this is how it should be (the air has compressed inside).