Hoop made of satin ribbons with a composition of chrysanthemums
A headband with flowers will decorate a girl's hairstyle at school, in the garden, on a walk or even at school. The composition consists of 2 chrysanthemums of a larger and smaller size.
To make jewelry you need:
- - red satin ribbon, width 1 and 2.5 cm;
- - felt bases;
- - hoop blank;
- - green ribbon for leaves;
- - glue;
- - lighter.
DIY satin ribbon hoop
For a large chrysanthemum, we use a ribbon 2.5 cm wide. It should be cut into 5 cm pieces.
Fold one piece of tape in half lengthwise and cut off the sharp corner.
Next, we secure the edge of the tape above the fire, do not touch the sharp edge, but on the other side we fold the corners into the middle, hold it with tweezers and secure the edge above the fire.
One sharp petal is ready. We will make all the other petals using the same principle.
For a large flower you will need 30 petals, for a small one - 20.
For a small chrysanthemum we use 3 cm pieces of red ribbon. Assembling a flower For a large flower we use a felt base with a diameter of 4 cm.
We distribute 12 petals along the edge of the circle. Next, we gradually fill the base with petals as densely as possible, then the flower will turn out more magnificent.
One flower can be attached to a headband and used for the little fashionistas.
We collect a small flower on a base with a diameter of 3 cm.
This is what the reverse side of each flower looks like.
On the front side, the flowers form a beautiful composition.
Glue three large leaves to the base of the large color, and three small ones to the base of the small one.
We wrap the hoop with a ribbon 1 cm wide. We glue the flowers onto the hoop so that the big one is closer to the center and the leaves are directed in different directions.
