How to make a sandblaster from a small gas cylinder

There is no more effective and versatile abrasive device than sandblasting. They can remove rust from surfaces with complex terrain, remove old paint, etc. If you have a compressor, you simply must make one, because it is not at all difficult.

Materials:

Gas cylinder 20 l;
nipples 1/2 inch – 2 pcs.;
pipe 25 mm;
pressure reducing valve with pressure gauge;
tees 1/2 inch – 2 pcs.;
ball valves 1/2 inch – 2 pcs.;
1/2 inch fittings for the hose – 3 pcs.;
cart wheels – 2 pcs.;
hose.

High-quality and durable drills on AliExpress at a discount - http://alii.pub/5zwmxz

The process of making sandblasting from a gas cylinder

First of all, unscrew the valve of the gas cylinder. Instead, you need to screw in the tube, having previously cut a thread on it. Through it we will pour sand into the balloon. You can close the tube with a regular plumbing plug.

We drill a hole in the side and cut a thread in it.

A nipple is screwed into it, onto which the tee is screwed.

We screw a regular ball valve into the tee.Then a pressure reducing valve with a pressure gauge is connected to it. Air from the compressor will be supplied directly through the latter.

A hole is visible in the bottom of the container.

A tee is also connected to it using a nipple.

Hose fittings are screwed into the open outlets of the tees. After this, you need to connect the upper and lower tees with a hose.

The air-sand mixture supply hose is connected to the open fitting at the bottom of the cylinder. Wheels and a leg are welded to the bottom of the cylinder.

A ball valve with a tip is installed on the sand supply hose. After this, you can fill in the sifted sand.

The filler neck is then closed with a plug.

Before turning on the compressor, all taps must be closed. When the receiver is full, open the first tap on the cylinder. As a result, air will fill the sandblast.